|
|
|
| |
 |
 |
SyneRAID™-1200U3R
Dual
Host Channel Clustering |
|
U3WSCSI/160MBs-to-UDMA/100/133 (Dual Host Channel Clustering):
3U 19" Rackmount RAID subsystem with Intel i80303
64bit RISC processor controller, 64MB Cache memory,
12 x hot swappable disk canister, hot swappable load
sharing redundant power supplies, one RS232 and one
3ft SCSI Cables.
|
SyneRAID™-1200U3T |
|
U3WSCSI/160MBs-to-UDMA/100/133 (Dual Host Channel Clustering):
Tower case RAID subsystem with Intel i80303 64bit RISC
processor controller, 64MB Cache memory, 12 x hot swappable
disk canister, hot swappable load sharing redundant
power supplies, one RS232 and one 3ft SCSI Cables.
|
SyneRAID™-1200FCR |
|
FC/200MBs-to-UDMA/100/133
(SAN Ready): 3U 19" Rackmount RAID subsystem with
Intel i80303 64bit RISC processor controller, 64MB
Cache memory, support Dual FC-AL loop, 2Gbit/sec per
loops, 12 x hot swappable disk canister, hot swappable
load sharing redundant power supplies , one RS232
cable and Manual. Includes RAID Management Software.
Fiber Cables Sold Separately
|
| |
|
|
|
|
U3WSCSI/LVD/160MBs Single Channel 64bit-PCI
SCSI Adapter w/LSI Symbios 53C1000R High Performance Chipset.
Compatible with NT4, Win2000, XP, SCO UNIX, UnixWare, Sun
Solaris OS, LINUX, and others.
|
SyneFCA™-2GHC
SyneFCA™-2GDB
|
64bit PCI 2GB Fibre Channel Low Profile, Copper Type w/ HSSDC
and DB9 Connector. Built-in Qlogic ISP2310 RISC Processor,
400Mbytes/sec Fibre Channel Transfer Rate in full Duplex Mode,
FC-AL Private & Public Loop, Point-to-Point, Switched
Fabric, FL-Port, F-Port for Fabric Log-in. Concurrent SCSI,
IP, Virtual Interface (VI) Protocol and FC Tape Support, Class
2 and 3 Fibre Channel Service, BIOS Support (Local & Fabric)
|
|
| |
-
High Performance Intel i80303 64-bit RISC Microprocessor.
-
2Gbit FC-AL/200MBs or U3WSCSI/160mbs interface provides
high performance data transfer rate.
-
Up to 512MB cache with tuning options to match your
data trends.
|
-
Redundant, hot-swappable blower fans ensure unit's
easy air flow for temperature reduction.
-
N+1 Redundant, hot-swappable, load-sharing power supplies
ensure system up time and offers protection against
power surges and spikes.
-
Supports multiple, global hot spares for complete data
protection.
-
Dynamic cooling system with inteligent fan controller
for high RPM hard drives.
-
Backplane designed for increased reliability &
hot-swapability.
-
Proprietary chassis design for enclosure management
& status report of all components.
|
| 
-
Host independent controller-based LUN mapping for multiple
server environments.
-
Supports multiple ID & multiple LUN.
-
Supports a wide variety of IDE disk drive capacities
with different IDE and EIDE technologies.
-
Scale to Terabyte solutions on a single RAID controller.
|
|
| |
|
| Form Factor: |
19-inch Rackmount by 3U High
20.5-inch Tower by 3U Wide |
| Host Interface: |
Dual U3WSCSI/LVD/160mb Channels or Dual
Loop 2Gbit Fibre Channels 200mbs |
| System Architecture: |
OS independent and Host Transparent, Intel
i80303 64-bit RISC Processor, RAID level 0, 1, (0+1), 3, 5,
Cache Memory up to 512MB |
| Backplane Design: |
Supported 12-bay ATA/33/66/100/133 IDE
Hot-Swap Disk Drives |
| Hot-Swap Components: |
Hard Drives, Power Supplies, Cooling Fans |
| Redundant Components: |
Hard Drives, Power Supplies, Cooling Fans |
| Enclosure Management
& Error Notification: |
Temperature Failure, Fan Failure, Power
Failure Monitor and Report. Audible Alarm, Status LEDs, SNMP
traps, Network Messaging, & Remote Paging |
|
| Number of Drives: |
1-to-12. Start with any drive number and
add as your need increases |
| Host Type: |
Dual U3WSCSI/160mbs Channels or Dual Loop
FC-AL 200mbs, 2Gbit |
| Drive Type: |
Low-profile (1-inch high) IDE Disk Drive:
(Will not accept Western Digital Drives
due to non-standard connectors) |
| Drive Capacity: |
Up To 160GB (5,400 and 7,200 RPM) Fully
Tested |
| Maximum Cap/Enclosure: |
1.90TB (12 x 160GB) w/ RAID 0, No Hot-Spare
1.76TB (12 x 160GB) w/ RAID 3, 5, No Hot-Spare
1.60TB (12 x 160GB) w/ RAID 3, 5, and Hot-Spare |
|
| Input Voltage: |
115/240 VAC 60/50Hz |
| Power Supply Rating: |
3 x 250 Watt Hot-Swappable PSUs (500W 2+1) |
|
CERTIFICATION COMPLIANCES |
| Emission Requirements: |
FCC Class A |
| Safety Requirements: |
UL1950, CSA #950, TUV/EN60950 |
| CE Compliance(EMC): |
89/336/EEC EMC Directive |
PHYSICAL CHARACTERISTICS RACKMOUNT |
| Width: |
16.77" (426mm) |
| Length: |
21.30" (541mm) |
| Height: |
5.20" (132 mm) (3U), 20.5" (512.50mm) Tower |
| Weight: |
37.5 lbs. (17Kg) w/odrives |
ENVIRONEMENT |
| Ambient Temperature: |
-Operating: 5°C to 35°C Non-operating/Storage:
- 40°C to 70°C |
| Relative Humidity: |
95% @ 30C (non-condensing) |
| Storage Management: |
Java-based GUI RAID Management Software
(Option) |
|
|
|
|
